1.在涂胶过程中，中心中止时刻较长，或多次堆集，而且在上胶结束时无法完成清洁，非常是在夏日温度较高时。

During the gluing process, the center stops for a long time or accumulates multiple times, and cleaning cannot be completed at the end of gluing, especially during high summer temperatures.

2. AB成分的气压缺乏，导致混合不均匀，凝胶缓慢，简单发生颗粒

2. Lack of air pressure of AB component leads to uneven mixing, slow gel and simple particles

3. B组件未经检查和清洁。 B成分对水蒸气敏感。由于运送和储存环境等偶尔因素，B组分的外表可能会结皮，外壳的一部分被压入管道中，这很简单发生颗粒。

3. Component B has not been inspected and cleaned. Component B is sensitive to water vapor. Due to occasional factors such as transportation and storage environment, the surface of component B may crust, and a part of the shell may be pressed into the pipeline, which can easily cause particles to occur.

4.过滤器和单向止回阀长时刻未清洗。

4. The filter and one-way check valve have not been cleaned for a long time.

5.B组件压板上的O形圈，运用时刻长，松动。

The O-ring on the pressure plate of component B has a long service life and is loose.

丁基胶打胶机阻塞解决方案：

Solution for blockage of butyl adhesive applicator:

1、断开胶水需求花费多长时刻，主张在断开时刻之前，依据每天的温度和湿度的不同，在每天施加胶水之前丈量剥离时刻。另外，目前的客户常常要求胶水的固化时刻要快，中止时刻要长一些，而且简单引起颗粒的呈现。

1. How long does it take to disconnect the adhesive? It is recommended to measure the peeling time before applying the adhesive every day based on the temperature and humidity difference before the disconnection time. In addition, current customers often require the curing time of adhesive to be fast, the stopping time to be longer, and it can easily cause the appearance of particles.

2、简单的处理办法是运用刮刀清洁外壳，而不影响胶水的运用。

2. The simple solution is to use a scraper to clean the outer shell without affecting the application of glue.

3、主张定期清洁过滤器，单向止回阀，静态混合器和胶枪。

3. Advocate regular cleaning of filters, one-way check valves, static mixers, and glue guns.